Setup Functions - Honeywell VisionPRO TH8000 Series Installation Manual

Installer setup
Function
0120
DONE
Press to
st
select function

Setup functions

Shaded areas below apply only to TH8320/TH8321.
0120 Year
(first two digits)
0130 Year
(second two digits)
0140 Month
0150 Date
0160 Schedule format
0170 System type
0180 Fan control
(heating)
0190 Changeover valve
(O/B terminal)
0200 Auxiliary heat
0210 External fossil
fuel kit
0220 1st stage com-
pressor cycle rate
0230 2nd stage com-
pressor cycle rate
Setting
20
Press to
st
change setting
Settings & Options
20 (2001-2099)
21 (2100-2178)
12 (2012)
[Other options: 00-99]
6 [Other options: 1-12]
15 [Other options: 1-31]
4 7-day programming
0 Non-programmable
1 1 heat/1 cool conventional
2 1 heat/1 cool heat pump (no aux. heat)
3 Heat only (2-wire systems)
4 Heat only with fan
5 Hot water Series 20 system (power to open & close zone
valves/normally open zone valves)
6 Cool only
7 2 heat/1 cool heat pump (with aux. heat)
8 2 heat/2 cool multistage conventional
9 2 heat/1 cool multistage conventional
10 1 heat/2 cool multistage conventional
11 2 heat/2 cool heat pump (no aux. heat)
12 3 heat/2 cool heat pump (with aux. heat)
0 Gas/Oil heat (equipment controls heating fan)
1 Electric furnace (thermostat controls heating fan)
0 O/B terminal controls valve in cooling
1 O/B terminal controls valve in heating
0 Electric backup heat
1 Fossil fuel backup heat
1 External fossil fuel kit controls backup heat
0 Thermostat controls backup heat (outdoor sensor required)
3 Recommended for most compressors
[Other options: 1, 2, 4, 5 or 6 CPH]
3 Recommended for most compressors
[Other options: 1, 2, 4, 5 or 6 CPH]
VisionPRO
0120
DONE
Press DONE to exit & save settings.
(factory default in bold)
7
TH8000 Series
TM
20
MCR29486
Continued on next page
69-2693—01