Wallplate Installation - Honeywell VisionPRO TH8000 Series Installation Manual

Installation Guide

Wallplate installation

1. Separate wallplate from thermostat.
2. Mount wallplate as shown below.
Drill 3/16" holes for drywall.
Drill 7/32" holes for plaster.
Wall anchors
Must be installed by a trained, experienced technician
• Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
69-2693—01
Grasp top and bottom of wallplate
and pull to remove from thermostat.
+
+
+
Wire hole
2
MCR29480
Mounting screws
MCR29481