Advertisement
CHARGING THE CAPACITOR AND WIRING:
The capacitor must be charged before connecting the Power and Ground
cables to the capacitor. Failure to charge the capacitor will result in a
large spark generated from the rapid inflow of current.
To Charge the capacitor:
1. Make Capacitor positive terminal connections with amplifier and
tighten the bolt. Do not over-tighten the bolts!
Caution:
Stripped terminals are not covered under the capacitor's
warranty.
2. Connect the ground cable with battery, amplifier, then refer to the
attached drawing.
3. Place the supplied charging bulb or resistor between the positive
terminal of the capacitor and the battery's positive terminal. Do this
for 30 seconds or until the charging bulb goes out.
Caution:
The charging bulb will get hot!
4. Immediately after the charging process, take out the charging bulb
from the connecting wire. And connect the positive cable of the
battery directly to the positive terminal on the capacitor.
WHEN YOU WANT TO MOVE THE CAPACITOR FROM
ORIGINAL INSTALLED CAR AUDIO SYSTEM, YOU MUST FIRST
FOLLOW DISCHARGING PROCESS AFTER TAKING OUT THE
CAPACITOR FROM THE CAR AUDIO SYSTEM.
3
Advertisement
