Patton electronics 2041 User Manual page 5

The Model 2041 is easy to install and is ruggedly designed for
excellent reliability. The following instructions will help you set up and
install the Model 2041 properly.
To use the Patton Model 2041, you must first configure the unit for
your application. To do so, first open the case by inserting a flat head
screw driver into an open slot on either side of the case, as in Figure 1.
Figure 1: Using a Small Screw Driver to Open the Model 2041 Case
Twist the screw driver head slightly and the top half of the case will
separate from the lower half, as in Figure 2. You now have access to
the internal switches used to configure the unit.
Figure 2: Using a Small Screw Driver to Open the Model 2041 Case
After opening the case, please refer to the section that pertains to
your unit for configuration details:
Patton Model Number
Model 2041FT-MC ....................................................3.1
Model 2041FC-MT ....................................................3.2
To close the case, fit the 2 halves together snugly and snap them
back in place.
3.0 CONFIGURATION
4
Section