Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Patton electronics 2086 Series
Summary of Contents for Patton electronics 2086 Series
- Page 1 MODEL 2086 Series Optically Isolated RS-232 to RS-485 Interface Converter Part# 07M2086-C SALES OFFICE Doc# 055051UC (301) 975-1000 Revised 05/11/99 TECHNICAL SUPPORT C E R T I F I E D (301) 975-1007 An ISO-9001 http://www.patton.com Certified Company...
-
Page 2: Warranty Information
EST, Monday through Friday. with the manufacturer's instructions—may cause interference to radio and television reception. The Model 2086 Series has been tested and found to comply with the limits for a Class A computing device in accor- dance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interfer- ence in a commercial installation. - Page 3 “controlled by DTR” • Compact size ( 3.8” x 2.10” x 0.8”) Figure 1. Top View of Model 2086 Series board, showing Dip switch and jumpers • Twisted pair connection via strain relief, RJ-11 or RJ-45 • 2500 Vrms Optical Isolation 3.1 DIP SWITCH CONFIGURATION...
-
Page 4: Jumper Configuration
RTS Control DTR Control Reserved always off RS485 TX always ON When Switch S2 is in the ON position, the DTE input signal DTR (Pin 20) RS-485, FDX, is used to control the transmitter of the Model 2086 Series. In this mode, when Transmitter is always on... -
Page 5: Installation
Once you have properly set the configuration switches and jumpers, you "cross over" cable. The diagram below shows how a cross over cable are ready to connect the Model 2086 Series to your system. This section tells should be constructed for an environment where both the Model 2086 you how to properly connect the Model 2086 Series to the RS-485 and RS-232 Series and the RS-485 device use a 6-wire RJ-11 connector. - Page 6 Figure 2 (below) shows how to wire the two-pair cables properly for a Model 2086 Series star topology. Note that the ground connec- (Note: If you must use a cable to connect the Model 2086 Series tion is not needed.
-
Page 7: Terminal Block
4.5 OPERATING THE MODEL 2086 SERIES Once the Model 2086 Series is properly installed, it should operate transparently—as if it were a standard cable connection. Operating power is derived from the RS-232 data and control signals; there is no “ON/OFF” switch. -
Page 8: Specifications
APPENDIX A APPENDIX B PATTON ELECTRONICS MODEL 2086 SERIES PATTON ELECTRONICS MODEL 2086 SERIES SPECIFICATIONS RS-232 PIN CONFIGURATIONS Transmission Format: Asynchronous DIRECTION “DCE Female” SETTING DIRECTION Data Rate: Up to 115,200 bps Range: 4,000 feet RS-232 Interface: DB-25, female, male... - Page 9 APPENDIX C PATTON ELECTRONICS MODEL 2086 SERIES LIST OF AVAILABLE MODELS DB25 REMOTE MODEL CONNECTOR CONNECTOR 2086M Male Terminal Block 2086F Female Terminal Block 2086MRJ45 Male RJ45 2086FRJ45 Female RJ45 2086MRJ11 Male RJ11 2086FRJ11 Female RJ11 2086M/230 Male Terminal Block...