147001UA Table of Contents CHAPTER 1 - Operation CHAPTER 2 - SETUP AND INSTALLATION Installation ... 2-1 Selection of DTE/DCE ... 2-1 Equipment Grounding ... 2-2 LED Indicators ... 2-2 Factory Test Straps ... 2-2 APPENDIX TECHNICAL SPECIFICATIONS ... A-1 V.35 Interface Pins Supported ...
Page 3
147001UA PROPRIETARY NOTICE The information contained herein is proprietary and confidential to Patton Electronics Co. Any reproduction or redistribution of this publication, in whole or in part, is expressly prohibited unless written authorization is given by Patton Electronics Co. WARRANTY NOTICE WARRANTIES: Patton Electronics Co.
RS-232 on the Modem Port, the 2020P (IC-V.24/V.35) can satisfy either interface conversion requirement. Devices can be sepa- rated up to 600 feet away from the 2020P (IC-V.24/V.35) on the V.35 side and RS-232 devices can be extended up to 50 feet away. The unit is supplied with a female DB-25 connector on the RS-232 port and a female 34 pin connector on the CCITT V.35 port.
Installation Set switches to match the required configurations based on the diagrams below. The cabling between each device and the 2020P (IC-V.24/V.35) must be terminated with male connectors. J1 is the RS-232 / V.24 interface and J2 is the V.35 interface. The IEC connector is provided to interface to the power plug required in the country of use.
Transmit Data (TD), Receive Data (RD), Request to Send (RTS), Clear To Send (CTS) and Carrier Detect (DCD). Factory Test Straps The Factory Test Straps JP1, JP2 and JP3 must be installed for proper operation of the 2020P (IC-V.24/V.35). V.24 INTERFACE V.24 INTERFACE...
APPENDIX TECHNICAL SPECIFICATIONS Applications RS-232 to CCITT V.35 interface conversion Capacity One RS-232 Channel One CCITT V.35 Channel Data Format Transparent to Data Data Rates Up to 128Kbps Electrical Interface RS-232 and CCITT V.35 RS-232 Physical Interface Female DB-25 Connector V.35 Physical Interface Female V.35 (M34) Connector DCE / DTE Configuration...