Panasonic DVCPRO AJ-D410AP Operating Instructions Manual page 18

Viewfinder displays
Display item
8 Shutter speed 1/¢¢.¢
1/100 - 1/2000
SUPER V
9 LOW LIGHT warning LOW LIGHT
display
: Audio level meter
display
; VTR warning REC WARNING
display/voltage SLACK E-¢¢
warning display
HUMID
SERVO
RF
TAPE NEAR END
TAPE END
BATT NEAR END
BATT END
BACKUP BATT EMPTY
WIRELESS RF
FULL
< FULL AUTO/SCENE
Filename which has been set
FILE display
= AWB color AWB+¢¢
temperature fine
adjustment amount
display
Z00 - Z99
> Zoom display
? AWB color
¢.¢K
temperature display
Ach
@ ATW, AWB channel
Bch
display
PRE
ATW
NC
A F value display
OPEN
F2.0 - F16
CLOSE
B Gain display 0 - 36dB
C Filter display FL1 - FL4
FL–
D Calendar/clock Sep-01-01 00:00:00
display
E Remaining battery
¢¢.¢V
charge display B ∫∫∫∫
¢¢%
What is displayed
Displayed when the shutter speed has been set to SYNCHRO SCAN.
Displayed when a fixed shutter speed has been set.
Displayed when SUPER V (high vertical resolution mode) has been set.
Displayed when the brightness has been reduced.
Indicates the audio levels of CH1 and CH2 (see page 29).
Indicates the occurrence of an error during recording.
Indicates the occurrence of an error caused by the mechanism. Depending
on the type of error, the power may be cut off automatically.
<Note>
For details on the codes displayed, refer to "Error codes" (page 42).
Indicates that condensation has formed.
Servo lock is not engaged during recording or playback.
The signal level from the tape has dropped.
The tape is nearing its end (there are about 2 minutes left).
The tape has stopped at the tape end.
The battery is nearly flat.
The tape has stopped because the battery is flat.
It is time to replace the backup battery.
The strength of the RF signal from the wireless receiver has dropped.
Displayed when the FULL AUTO switch has been set to ON.
Indicates the filenames (8 characters) set for the scene files.
The adjustment amount is displayed when ON has been selected as the
"COLOR TEMP" setting (see page 38) and the color temperature has been
adjusted finely. It is not displayed when OFF is selected or only ATW has
been set.
Indicates the zoom amount. However, most 1/2-inch size lenses have no
zoom position return. In such a case, this item is not displayed even if ON
has been selected as the display setting.
Indicates the color temperature.
The WHITE BAL switch has been set to channel A.
The WHITE BAL switch has been set to channel B.
The WHITE BAL switch has been set to PRE.
The full time auto white balance has been set.
Displayed when the lens cable has not been connected.
Displayed when the lens iris has been opened.
Indicates the lens iris value.
Displayed when the lens iris has been closed.
<Note>
This item appears when using a lens equipped with a function that displays
the aperture value.
Displays the current gain value.
Displays the filter position.
Displayed when filter has not been set to the proper position.
Month-day-year and hours-minutes-seconds displayed.
(The 24-hour system is used for the clock display)
The input voltage is displayed.
The number of "∫" squares serves as a rough guideline to indicate how
much battery charge remains. When the battery still has a sufficient charge,
four of these squares are displayed.
The remaining battery charge is displayed as a percentage figure when an
ANTON-D or IDX-D digital battery is used.
Status causing the display to appear
18