Speaker Placement; Stage Monitor/P.a. Loudspeakers; Operations - VocoPro UHF-8800 Owner's Manual

UHF-8800 & stage monitor/p.a. loudspeakers
If you will be using the UHF-8800 with stage monitors and/or P .A. system, try the following:
• Place the stage monitor directly behind the microphone.
• Locate the P .A. loudspeakers so that they point away from the rear of the microphone. (With the speakers
located in these positions, the possibility of feedback is greatly reduced).
• Always check the stage setup before a performance to ensure optimum placement of microphone and
monitors.
IMPORTANT: Every wireless microphone installation is a unique situation, and can present a variety of
problems. Never attempt a live performance without first conducting a "walkthrough" test of the system in
the performing area. If major changes (additional wireless systems or intercoms, relocation of scenery, etc.)
have been made since the last walk-through test, check the wireless system again, as close to performance
time as possible.

Operations

1. Press the POWER button on the UHF-8800 receiver's front panel.
2. Adjust the receiver's VOLUME controls to approximately 50%.
3. Switch the microphone's POWER BUTTONS to the ON positions.
4. Talk or sing into the microphones. During normal operation, the RF/AF signal LED's will light when a
microphone is being used.
5. Adjust the receiver's VOLUME controls until the output levels are balanced with eachother and other
possible source output i.e. CD+G tracks.
P.A. Speakers Facing Away
From Rear of Microphone
Monitor Directly Behind
Microphone
14