Network; Wan - TP-Link TL-WR743ND User Manual

WISP, the Wireless port works as a WAN port at Client Router mode. The Ethernet port acts
as a LAN port.
Router - In this mode, the device enables multi-users to share Internet via ADSL/Cable

Modem. The wireless port share the same IP to ISP through Ethernet WAN port. The Wireless
port acts the same as a LAN port while at Router mode.
Repeater - In this mode, the AP will relays data to an associated root AP. AP function is

enabled meanwhile. The wireless repeater relays signal between its stations and the root AP
for greater wireless range.
Bridge with AP - In this mode, the device bridge to another AP.

Client - In this mode, the device will act as a wireless station to enable wired host(s) to access

AP.

4.6 Network

Figure 4-6 the Network menu
There are three submenus under the Network menu (shown in Figure 4-6): WAN, MAC Clone
and LAN. Click any of them, and you will be able to configure the corresponding function.
4.6.1

WAN

Choose menu "Network → WAN", and then you can configure the IP parameters of the WAN on
the screen below.
1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will
automatically get IP parameters from your ISP. You can see the page as follow (Figure 4-7):
TL-WR743ND 150Mbps Wireless AP/Client Router
- 45 -