The Rear Panel - TP-Link TL-WR740N User Manual

1.4.2

The Rear Panel

The following parts are located on the rear panel (View from left to right).
RESET:
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2) Use the Factory Default Reset button: Press the Reset button for five seconds and then
wait for the Router to reboot.
POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR740N/TL-WR741ND 150Mbps Wireless N
Router.
ON/OFF: The switch for the power.
1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the Router to the local PC(s).
WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet.
Wireless antenna: To receive and transmit the wireless data.
QSS: If you have client devices, such as wireless adapters, that support Wi-Fi Protected
Setup, then you can press this button to quickly establish a connection between the Router
and client devices and automatically configure wireless security for your wireless network.
For detailed information, please refer to
TL-WR740N/TL-WR741ND
Figure 1-2 Rear Panel sketch
4.4 QSS.
5
150Mbps Wireless N Router