Forwarding; Virtual Servers - TP-Link TL-WR740N User Manual

Click the Enable/ Disable All button to make all entries enabled/disabled
Click the Delete All button to delete all entries
Click the Next button to go to the next page and Click the Previous button to return to the
previous page.
4.8

Forwarding

Figure 4-29 The Forwarding menu
There are four submenus under the Forwarding menu (shown in Figure 4-29 ): Virtual Servers,
Port Triggering, DMZ and UPnP. Click any of them, and you will be able to configure the
corresponding function.
4.8.1

Virtual Servers

Choose menu "Forwarding→Virtual Servers", and then you can view and add virtual servers in
the next screen (shown in Figure 4-30 ). Virtual servers can be used for setting up public services
on your LAN. A virtual server is defined as a service port, and all requests from Internet to this
service port will be redirected to the computer specified by the server IP. Any PC that was used
for a virtual server must have a static or reserved IP address because its IP address may change
when using the DHCP function.
Service Port - The numbers of External Service Ports. You can enter a service port or a
range of service ports (the format is XXX – YYY; XXX is the Start port and YYY is the End
port).
Internal Port - The Internal Service Port number of the PC running the service application.
You can leave it blank if the Internal Port is the same as the Service Port, or enter a
specific port number when Service Port is a single one.
TL-WR740N/TL-WR741ND
Figure 4-30 Virtual Servers
49
150Mbps Wireless N Router