Using A Password - Franklin Merriam Webster Dictionary MWD-450 User Manual

You can use a password to keep the
information in the Phone List private.
The password is requested when the
unit is turned on and the Phone List is
accessed.
Password Warnings
Warning! After you set the password,
you must enter the password to access
the phone list for the first time during a
session. Always record your password
and keep it in a separate place.
If you forget the password, you must
reset the unit to access the phone list.
Warning! Resetting the unit erases all
user-entered information. Always keep
written copies of your data.
If you do not have a reset button locat-
ed on the back of your unit, remove the
batteries, wait at least two minutes, and
then re-install them. For battery instruc-
tions, see Installing the Battery on page
5.
If you have a reset button, use the end
of a straightened paper clip to gently
press the reset button.

Using a Password

If the unit does not reset after pressing
the reset button, follow the above
instructions for removing the batteries.
1. Press DATA.
2. Press
3. Type a password and then press
4. To test the password, press
5. To disable the password, repeat
16
Password Setup
or
Password and press ENTER.
ENTER.
Your password can have up to 8
characters.
You are prompted to retype your
password, and press ENTER to
confirm.
ON/OFF twice, press DATA, type
the password, and press ENTER.
Steps 1 and 2 above, and press
ENTER when Enter Password
displays.
to see Set