Table of Contents
Advertisement
Available parameters are listed as follows:
Item
Filter Rule
Policer
Drop
Reserved
IP Protocol
Source IP Address
Source IP Address
Mask
Source Port Enable
Source Port Start
Source Port End
Destination IP
Address
Destination IP
Address Mask
Destination port
Enable
Destination Port
Start
Destination Port
End
Apply
Description
Display the profile name of the filter rule.
Choose the QoS Policer profile to apply to such filter rule.
Choose Enable to discard the packets which satisfy the
condition of the filter rule.
Choose Enable to keep the packets which satisfy the
condition of the filter rule, even the system is busy.
When both Drop and Reserved are set to Enable, the
priority of Drop is higher than Reserved.
Choose a protocol for such filter rule.
Type the source IP address for such incoming filter rule.
Type the mask address for the source IP address.
Choose Enable to restrict the source port value.
Type the starting port number (0 - 65535) in the range of the
source port.
Type the ending port number (0 - 65535) in the range of the
source port.
Type the destination IP address for such incoming filter rule.
Type the mask address for the destination IP address.
Choose Enable to restrict the destination port value.
Type the starting port number (0 - 65535) in the range of the
destination port.
Type the ending port number (0 - 65535) in the range of the
destination port.
Click it to save the configuration and exit the page.
168
Vigor300B Series User's Guide
Advertisement
Table of Contents
