Led Indicators And Connectors; For Vigorpro 5510 - Draytek VigorPro 5510 Series User Manual

1 . 2 L E D I n d i c
1 . 2 L E D I n d i c
Before you use the Vigor router, please get acquainted with the LED indicators and
connectors first.
1 . 2 . 1 F o r V i g o
1 . 2 . 1 F o r V i g o
LED
ACT (Activity)
IDP (Intrusion Detection and
Prevention)
Virus
DMZ
USB
Monitor
CSM
LED on Connector
WAN
LAN/Monitor
LAN
Interface
RST
(Factory Reset)
a t o r s a n d C o n
a t o r s a n d C o n
r P r o 5 5 1 0
r P r o 5 5 1 0
Status
Blinking
Off
On
(Yellow)
On
(Yellow)
On
On
Blinking
On
On
Off
10 On
(left LED)
Off
Blinking
100 On
(right LED)
Off
Blinking
100 On
(left LED)
Off
Blinking
1000 On
(right LED)
Off
Blinking
Description
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
n e c t o r s
n e c t o r s
Explanation
The router is powered on and running normally.
The router is powered off.
The anti-intrusion function is enabled.
The anti-virus function is enabled.
DMZ Host is specified in certain site.
A USB device is connected and active.
The data is transmitting.
LAN traffic monitor is active.
The profile(s) for IM/P2P, Web Content Filter,
and/or URL Content Filter application has been
activated. (It is enabled from Firewall >> General
Setup).
No IM/P2P, Web Content Filter, and/or URL
Content Filter application has been activated.
The port is connected with 10Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is disconnected.
The data is transmitting.
2
VigorPro5510 Series User's Guide