The new S2 Signature Series Dual Channel Tube Compressor is the latest product to emerge from Ivor Drawmer’s high end designs and offers an ‘all tube - no technical compromise’ circuit using only the highest grade components. The S2 features a host of new creative processing possibilities never before found in an all analogue dynamics package.
INSTALLATION The S2 is designed for standard 19" rack mounting and occupies 3U of rack space. Fibre or plastic washers may be used to prevent the front panel becoming marked by the mounting bolts. Always connect the mains earth to the unit.
• Interference: If ground loop problems are encountered, never If the S2 is to be used where it maybe exposed to high disconnect the mains earth, but instead, try levels of disturbance such as found close to a TV or...
0.2 to 0.6 seconds is a good starting point. Be careful with very long release settings, the Compressor might never have enough time for a total recovery between the signal peaks. However, if set too fast, the signal may “pump”, which can be used creatively, but is generally undesirable. DRAWMER S2 O PERATOR’S ANUAL...
Page 7
Dry works by adding the original signal coming into the unit to the compressed signal that has been processed by the S2, effectively reducing the percieved amount of compression taking place. It is easiest to think of it as being similar to a parallel compressor, but with the advantage of being one simple knob. It provides completely variable control over the whole amount of compression taking place without having to alter numerous settings in order to do so.
Page 8
Temperature Led The S2 is at optimum temperature when the front panel LED indicator is lit, i.e. after the soft start and when the valves have reached optimum temperature - this may take a few seconds.
Release control. Bear in mind that too short a release time will result in pumping. to d At this point the Bypass switches can be toggled to listen to the affect that the S2 is having on the audio. Repeat steps 2,3 and 4 to suit.
Please address correspondence to: the difficulty. A list of all main dealers can be found on the Drawmer Drawmer (Technical Help line) webpages. Coleman Street...
Need help?
Do you have a question about the S2 and is the answer not in the manual?
Questions and answers