THREE-BAND STEREO VACUUM TUBE COMPRESSOR INTRODUCTION The new S3 Three-Band Stereo Vacuum Tube Compressor components. The S3 forms the basis of a 'Signature Series' incorporates the very latest in Ivor Drawmer designs and and offers previously unattainable control and tonality over...
It is also recommended to the S3 is mounted horizontally to allow heat to escape vertically through the vents on the lid. To mount at an angle may cause the S3 to overheat which will damage internal components (see fig. 2).
• Interference: If ground loop problems are encountered, never If the S3 is to be used where it maybe exposed to high disconnect the mains earth, but instead, try levels of disturbance such as found close to a TV or...
High Split Frequency: 1.4kHz - 14kHz Sets the frequency point at which the split between mid and high bands occurs. The following diagram provides a good, but general, idea of some useful frequencies: DRAWMER S3 O PERATOR’S ANUAL...
Page 7
During compression the signal is attenuated, gain may be required to produce the required output level. In addition, as the S3 is multi-band, the three gain controls are used to adjust the levels of each band to obtain a desirable overall signal, or to bring out the bass, treble etc.
Page 8
OUTPUT Temperature Led The S3 is at optimum temperature when the front panel LED indicator is lit, i.e. after the soft start and when the valves have reached optimum temperature - this may take a few seconds. Gain:...
7) The Threshold and Gain of each band can be modified to achieve the desired compression, levels and tonal balance to the overall signal. 8) At this point the Bypass switches can be toggled to listen to the affect that the S3 is having on the audio. Adjust to suit.
Please address correspondence to: the difficulty. A list of all main dealers can be found on the Drawmer Drawmer (Technical Help line) webpages. Coleman Street...
Need help?
Do you have a question about the S3 and is the answer not in the manual?
Questions and answers