Table of Contents
Advertisement
Installing Batteries
Note: If battery insulation tape is in-
stalled, carefully remove it by pulling
the battery installation tape out of the
battery compartment.
BOOKMAN 440 models use two
CR2032 3-volt batteries. Here is how
to install or replace the batteries.
Warning: When the batteries lose
power or are removed from your
BOOKMAN, information that you en-
tered in its built-in book, and in an in-
stalled book card, will be erased.
1. Turn your BOOKMAN over.
2. Slide off its battery cover in
the direction of the triangle.
3. Install the batteries with
their plus signs facing you.
4. Replace the battery cover.
Follow the Arrows
The flashing arrows on the right of
the screen show which arrow keys
you can press to move around the
screen.
Installing a Book Card
Warning: Never install or remove a
book card while your BOOKMAN is
turned on. If you do, information that
you have entered in the built-in book,
as well as in any other installed book
cards, may be erased.
1. Turn your BOOKMAN off.
2. Turn your BOOKMAN over.
3. Align the tabs of the book card
with the notches in the slot.
4. Press the book card down
until it snaps into place.
Removing Book Cards
Warning: When you remove a
book card to install another, informa-
tion that you entered in the removed
book card may be erased.
4
Advertisement
Table of Contents
