Maintenance - Dimplex ELECTRALOG CS4416 Owner's Manual

Operation
Battery Replacement
1. Slide battery cover open on
the remote control (Figure 2).
2. Correctly install one (1) 12
volt (a23) battery in the
battery holder.

Maintenance

 
WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
Helpful Hints: It is a good idea to
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
reduce the number of times you
need to open the unit to replace
light bulbs.
Light Bulb Replacement
Allow at least five (5) minutes for
the light bulbs to cool off before
touching to avoid accidental
burning of the skin. light bulbs
needs to be replaced when you
notice a dark section of the flame
or when the clarity and detail of
10
3. Close the battery cover.
battery must be recycled
or disposed of properly.
Check with your local
authority or Retailer for recycling
advice in your area.
the log exterior disappears.
there are two (2) bulbs located
under the log Set which generate
the flames and embers.
Tools Required: Phillips
screwdriver
Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
and 25 Watt rating.
To Replace the Light Bulbs
①
Remove the five (5) screws
from the access panel, located on
the back of the unit, and remove
access panel (Figure 3).
②
locate and examine the bulbs
to determine if replacement is
required.