Volvo 850 Accessories Manual page 2

opening drain cocks on cylinder block and radiator. Remove front
wheels, steering arm/wheel spindle joints, and nuts securing ball
joints to support arms.
2) Remove ABS wire and brake line retaining bracket bolt
located on inner fender panel, close to bottom of strut. Remove left
drive axle shaft. See AXLE SHAFTS - FWD article in DRIVE AXLES
section. Disconnect 2 thin Black hoses from evaporative fuel canister.
Remove White vacuum hose from vacuum reservoir.
3) Remove right drive shaft and intermediate bearing cap.
Carefully place components on steering servo pipes. Remove 2 right
engine mounting bolts. Loosen wheel arch liner to allow access to
mounting. Remove torque arm in gearbox. See Fig. 1. Install Sealing
Plugs (5488) in drive shaft holes.
Fig. 1: Removing Drive Shaft, Engine Mount Bolt & Torque Arm
Courtesy of Volvo Cars of North America.
4) Remove front exhaust pipe nuts and springs. Remove front
exhaust pipe bolts. Disconnect speedometer. Remove engine mounting
shield bolt. Lower vehicle.
5) Remove battery, battery self, and fresh air hose between
air intake and air cleaner housing. Disconnect MAF sensor connector
and primary lead between distributor and coil. Remove throttle pulley
cover. If equipped with cruise control, disconnect all necessary
electrical wiring and vacuum hose.
6) Disconnect intake hose at throttle body and idle air
control valve hose. Disconnect vacuum hose and crankcase ventilation