Amana RS3100007 Service Manual page 57

36"
(min)
STANDPIPE
60" max
36" min
TUB
beaded tie-down strap
WALL UNIT
IMPORTANT: To prevent siphoning, do not place
ribbed portion of drain hose into standpipe. Avoid
air-tight seal around standpipe adapter.
standpipe
adapter
POSITION AND LEVEL WASHER
(avoid
Position washer on clean, dry, firm, and level floor. Place
air-tight
rubber foot pads on all four leveling legs.
seal)
NOTE: To avoid damage to legs and base, do
not slide washer across floor if leveling legs have
been extended.
beaded Loosen 7 / " locknuts and adjust front 2 leveling legs until
8
tie-down
machine is level front-to-back and side-to-side. Be sure
strap
machine does not rock. Tighten locknuts up to washer base,
or washer will move out of position during operation.
Once front legs are adjusted, gently tilt washer forward on
front legs and lower into place to correctly set rear self-
leveling legs. WASHER MUST NOT ROCK.
CONNECT POWER CORD TO ELECTRICITY
See Electrical Requirements on page 4.
Plug washer into 3-prong grounded outlet.
BEFORE FIRST USE TO WASH CLOTHES,
add water and detergent to washtub.
Run through one wash cycle.
To prevent damage to pump, add at least 1 quart of water
beaded
to tub before first use. Pump seal may overheat and leak if
tie-down
washer is used before water is added. Small amount of
strap
water from first use stays in drain system to cool pump and
prevent seal damage.
Questions?
See Washing Guide or call Amana
Consumer Affairs Department
1-800-843-0304
bubble level
locknut
leveling leg
rubber foot pad