Amana RS3100007 Service Manual page 31

Protect the floor when moving the
washer. Washer must be within 4 feet
of desired area before beginning
installation. Open washer lid and
remove installation parts from
shipping brace for use.
Reach through foam shipping
brace, grasp bottom of brace, and
pull up to remove.
Tightly push one flat rubber
washer into one end of each
water fill hose and attach this end
of hose to washer. HOT and
COLD connections are identified
by letters H and C stamped into
washer cabinet and by HOT and
COLD printed on water fill hoses.
RS3100007 Rev. 0
NOTE: Save shipping plug and
shipping brace; reinstall whenever
washer is moved more than 4 feet.
Do not lift or move washer without
shipping materials in place.
To remove the shipping plug from the
washer, step on the card board base,
tilt the washer back, and slide out the
base.
In most cases, hoses should
cross when attached to correct
water temperature faucet.
Tighten hose connections by hand
until snug, then another ¼ turn with
pliers. DO NOT cross-thread or over-
tighten couplings.
A–2
H C