Amana RS3100007 Service Manual page 33

Installation Instructions
Position washer in final location on clean, dry, firm, and
level floor.
NOTE: To avoid damage to legs and base, do not slide
washer across floor if leveling legs have been
extended.
7
1. Loosen /8" locknuts and extend front leveling legs.
Place rubber foot pads on all four leveling legs.
Adjust front 2 leveling legs until machine is level
side-to-side. Be sure machine does not rock. Tighten
locknuts up to washer base, or washer will move out
of position during operation.
2. Once front legs are adjusted, gently tilt washer
forward on front legs and lower into place to correctly
set rear self-leveling legs.
Check that washer is level front-to-back and side-to-side.
WASHER MUST NOT ROCK.
See Installation Requirements
section. Plug washer into
3-prong grounded outlet only.
RS3100007 Rev. 0
Wipe tub with clean rag and soap
diluted in warm water to remove
any oil used in manufacturing. Use
household spray cleaner if
necessary.
Add water and detergent to
washtub, and run before first use.
A–4