Volvo S70 Owner's Manual page 149

1999 S70 & V70
Due to the greater weight of AWD-equipped cars, these models have an additional jack attachment point
located directly in front of the rear axle. When using a workshop floor jack, make sure that the correct
attachment is used and that the jack does not damage the fuel tank.
The attachment is, of course, also intended for use with the standard jack supplied with the car.
Proper Jack attachment on AWD cars.
Installing the wheel
Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Make sure that
you align the wheel with the guide stud on the wheel hub prior to installation. Install the wheel bolts
crosswise (see illustration) and tighten by turning lightly clockwise. Lower the vehicle to the ground and
alternately tighten the nuts to 81 ft. lbs. (110 Nm). Install the wheel cap (where applicable).
file:///K|/ownersdocs/1999/1999_SV70/99sv70_091.htm (5 of 7)12/30/2006 3:37:03 PM
Correct tightening order for wheel bolts