Left-Hand Stalk Switch - Volvo XC90 Owner's Manual

02 Instruments and controls

Left-hand stalk switch

Stalk switch positions
02
Short flash sequence, direction indicators
Continuous flash sequence, direction indi-
cators
Main beam flash
Home safe lighting and switching of
dipped and main beam
1 Factory settings.
64
Direction indicators
Continuous flash sequence
±
Move the stalk switch up or down to end
position (2).
The stalk switch remains in its end position and
is moved back manually, or automatically by
steering wheel movement.
Short flash sequence
±
Move the stalk switch up or down to posi-
tion (1) and release, the stalk switch then
returns to its home position, or move the
stalk switch to position (2) and move it
directly back to the home position.
The direction indicators flash three times. Short
flash sequence interrupted immediately if indi-
cating is started in the opposite direction.
Switching, main and dipped beam
The remote control key must be in position II
for main beam to be switched on.
1. Turn the headlamp control clockwise to the
end position, see page 62.
2. Move the stalk switch towards the steering
wheel to the end position (4) and release.
Main beam flash
±
Move the stalk switch gently towards the
steering wheel to position (3).
Main beam comes on until the stalk switch is
released.
Home safe lighting
Some of the exterior lighting can be kept
switched on to work as home safe lighting after
the car has been locked. The standard delay is
1
30 seconds , but can be changed to 60 or
90 seconds.
1. Remove the remote control key from the
ignition switch.
2. Move the stalk switch towards the steering
wheel to the end position (4) and release.
3. Get out of the car and lock the door.