01 Safety
Seatbelts
01
Always use a seatbelt
Tensioning the hip strap. The belt must be posi-
tioned low down.
Heavy braking can have serious consequences
if the seatbelts are not used. Ensure that all
passengers use their seatbelts. It is important
that the seatbelt lies against the body so it can
provide maximum protection. Do not lean the
backrest too far back. The seatbelt is designed
to protect in a normal seating position.
Putting on a seatbelt:
±
Pull the seatbelt out slowly and secure it by
pressing the buckle into the lock. A loud
"click" indicates that the seatbelt has
locked.
18
Releasing the seatbelt
±
Press the red lock button and then let the
seatbelt retract. If the seatbelt does not
retract fully, feed the seatbelt in by hand so
that it does not hang loose.
The seatbelt locks and cannot be
withdrawn
•
if it is pulled out too quickly
•
during braking and acceleration
•
if the car leans heavily.
Keep in mind the following
•
do not use clips or anything else that can
prevent the seatbelt from fitting properly
•
ensure that the seatbelt is not twisted or
caught on anything
•
the hip strap must be positioned low down
(not over the abdomen)
•
tension the hip strap over the lap by pulling
the diagonal shoulder belt as illustrated.
WARNING
The seatbelts and airbags interact. If a seat-
belt is not used or is used incorrectly, this
may diminish the protection provided by the
airbag in the event of a collision.
WARNING
Each seatbelt is designed for only one per-
son.
WARNING
Never modify or repair the seatbelts your-
self. Volvo recommends that you contact an
authorised Volvo workshop. If a seatbelt has
been subjected to a major load, such as in
conjunction with a collision, the entire seat-
belt must be replaced. Some of the protec-
tive characteristics of the seatbelt may have
been lost, even if it appears to be undam-
aged. In addition, replace the seatbelt if the
belt is worn or damaged. The new seatbelt
must be type-approved and intended for
installation in the same position as the
replaced seatbelt.