Connecting Rj45 Ethernet Cable - Vivotek FE8171V User Manual

VIVOTEK

Connecting RJ45 Ethernet Cable

RJ45 Cable Dimension (unit: mm)
Recommended cable gauge: 24AWG (0.51 mm)
Assembling Steps
1
3
o: white/orange stripe
o
O: orange solid
O
g: white/green stripe
g
B: blue solid
B
b: white/blue stripe
b
G
G: green solid
br
br: white/brown stripe
BR
BR: brown solid
4
Connecting DC Power Cable
1. Remove the rubber stopper from the camera base.
2. Add the supplied rubber washer to the cable as shown in the picture.
3. Feed the cable from the bottom of the camera and tighten the plastic base for waterproofing.
10 - User's Manual
Rubber Seal
Plug
2
1
2
3
4
5
6
7
8
4. Feed the Ethernet cable from the bottom of the camera
and through the hole. Attach the rubber seal plug for wa-
ter proofing.
NOTE:
This equipment is only to be
connected to PoE networks
without routing to outside plant.
1. Drill a hole on the rubber seal plug and insert
an Ethernet cable through the opening.
2. Strip part of the sheath from the Ethernet ca-
ble.
3. You will need an RJ45 crimping tool to attach
the Ethernet wires to a connector. When done,
connect the cable to the camera's Ethernet
RJ45 socket.