Connecting Rj45 Ethernet Cable - Vivotek FE8171V Quick Installation Manual

Connecting RJ45 Ethernet Cable

RJ45 Cable Dimension (unit: mm)
Recommended cable gauge: 24AWG (0.51 mm)
Assembling Steps
1
3
o: white/orange stripe
O: orange solid
g: white/green stripe
B: blue solid
b: white/blue stripe
G: green solid
br: white/brown stripe
BR: brown solid
4
Connecting DC Power Cable
1. Remove the rubber stopper from the camera base.
2. Add the supplied rubber washer to the cable as shown in the picture.
3. Feed the cable from the bottom of the camera and tighten the plastic base for waterproofing.
Rubber Seal
Plug
2
o
1
O
2
g
3
4
B
b
5
G 6
br 7
BR 8
4. Remove the original black seal plug from the camera base. Then
feed the Ethernet cable from the bottom of the camera and through
the hole. Attach the rubber seal plug for water proofing.
1. Drill a hole on the rubber seal plug and
insert an Ethernet cable through the open-
ing.
2. Strip part of the sheath from the Ethernet
cable.
3. You will need an RJ45 crimping tool to
attach the Ethernet wires to a connec-
tor. When done, connect the cable to the
camera's Ethernet RJ45 socket.
EN - 6