Subscribe to Our Youtube Channel
Related Manuals for Visonic AMBER SELECT
Summary of Contents for Visonic AMBER SELECT
- Page 1 AMBER SELECT / AMBER SELECT User's Guide Wireless Emergency Response System D-301438 AMBER SELECT / AMBER SELECT USER’S GUIDE...
-
Page 2: Wireless Emergency Response System
AMBER SELECT / AMBER SELECT fire, the system can be programmed to automatically call the monitoring station or to private phones. The Unit includes a large display (not applicable to AMBER SELECT ) that shows the system status, the time and preprogrammed medication reminders. -
Page 3: Specifications
Supply Voltage: 12 VAC, 1 A (via 120VAC/60Hz TROUBLE (Red): Normally OFF. If LED flashes, transformer). there is a problem with the AMBER SELECT / Non-UL Compliant (AMBER SELECT only): AMBER SELECT or one of the devices (described Battery Pack: NI-MH 7.2 V, 1.3 Ah, type 103-301179. -
Page 4: Physical Properties
2. Enter all the desired programming information into the HHCPC. Connect one end of the special cable (supplied by Visonic) to one of the computer's COM ports and the other end to the AMBER SELECT / AMBER SELECT unit. For advanced phone connections see Customer Information. -
Page 5: Mounting The Unit
Figure 3a, until facing the other hole. Then Note: Certain remote areas of your residence may lie secure the screw. outside the reception range of the AMBER SELECT / 4. Connect the AC/AC adapter into a nearby electrical AMBER SELECT , resulting in the unit not being able outlet. -
Page 6: Battery Replacement
B. Press the button on the arm/disarm transmitter If you need emergency assistance, press the button on (MCT201WP). your pendant transmitter or press the large, red Direct Link (Speed Dial) – The AMBER SELECT / EMERGENCY button ( ) on your AMBER SELECT / ... - Page 7 08:25:53 PM AMBER SELECT / AMBER SELECT 2. Use Direct Link buttons 1 (scrolls up) and 2 (scrolls If you have a phone connected to the AMBER SELECT / down) to set the current field value. AMBER SELECT and want to use the phone to talk with 3.
-
Page 8: Remote Control By Telephone
Center representative about your system. Because the call controller or a Power Code transmitter (MCT-201WP). is non-emergency call, there might be a delay before the To arm the system by the AMBER SELECT / AMBER Monitoring Center representative responds. SELECT... - Page 9 "Common area" pressing the Check button on the AMBER SELECT / such as dining halls, craft areas, recreation areas, central hallways, etc. If someone needs to call for AMBER SELECTX unit.
-
Page 10: Pendant Transmitter Test
Your system informs the Monitoring Center. supervised MCT-212 flashes rapidly several times per The smoke detector's batteries should last at least one second and the red light on the AMBER SELECT / year. To replace the batteries, refer to the instructions AMBER SELECT flashes continuously until the provided with the smoke detector. -
Page 11: Troubleshooting
The following table provides a list of problems that may arise with the system together with possible solutions. PROBLEM DEFINITION SOLUTION The red light on the AMBER SELECT / The Base Unit informs your Press the CHECK button ( ) to... - Page 12 WATER FLOW ALARM PERIODIC TEST SYS TBL PRESENT AC LOSS POINT TESTED OK LOW SYSTEM BATTERY POINT NOT TESTED SYSTEM RESET SENIOR WATCH TROUBLE SYSTEM SHUTDOWN SERVICE REQUEST BATTERY TEST FAIL TIME/DATE INACCURATE D-301438 AMBER SELECT / AMBER SELECT USER’S GUIDE...
- Page 13 This equipment should be installed in accordance with Chapter 2 of the National Fire Alarm Code, ANSI/NFPA 72. D-301438 AMBER SELECT / AMBER SELECT USER’S GUIDE...
-
Page 14: Customer Information
Wireless emergency response system must be able to seize the telephone line and place a call in an emergency situation. It must be able to do this even if other equipment (telephone, answering system, computer modem, etc.) already has the telephone line in use. To do so, “AMBER SELECT / AMBER SELECT ”... - Page 15 Customer Premises Equipment and Wiring Service Provider's Computer RJ-31X Facilities JACK Unused Alarm Dialing RJ-11 Jack Equipment Telephone Line Telephone Network Unused Demarcation Fax Machine RJ-11 Jack Telephone Point Answering System Telephone D-301438 AMBER SELECT / AMBER SELECT USER’S GUIDE...
- Page 16 WARRANTY Visonic Limited (the “Manufacturer") warrants this product only (the "Product") to the original purchaser only (the However, if the Manufacturer is held liable, whether directly or indirectly, for any loss or damage arising under this “Purchaser”) against defective workmanship and materials under normal use of the Product for a period of twelve limited warranty, THE MANUFACTURER'S MAXIMUM LIABILITY (IF ANY) SHALL NOT IN ANY CASE EXCEED (12) months from the date of shipment by the Manufacturer.
Need help?
Do you have a question about the AMBER SELECT and is the answer not in the manual?
Questions and answers