Subscribe to Our Youtube Channel
Related Manuals for Visonic AMBER CLASSIC
Summary of Contents for Visonic AMBER CLASSIC
- Page 1 AMBER CLASSIC / AMBER CLASSIC X User's Guide Wireless Emergency Response System D-301436...
-
Page 2: Wireless Emergency Response System
In the event of fire, the system automatically calls AMBER CLASSIC X the Visonic monitoring station. The Base Unit includes a large display (AMBER CLASSIC only) that shows the system status, the time and preprogrammed medication reminders. MCT-211... -
Page 3: Specifications
Frequency: 315, 433 and 868 MHz - Speakerphone (hands-free) when Display (AMBER CLASSIC only): Dual line, communicating with Monitoring Center backlit 16-character display with 3 LED indicators. - The system supports up to 29 users (pendant Supply Voltage: 12 VAC,1 A transmitters and smoke detectors). -
Page 4: System Setup
In this case, a Repeater (MCX-600) can be used to increase the base unit reception range. Contact a Visonic representative for further details. Step 2 Figure 3 – Base Unit with Raised Antenna... - Page 5 When the panel is not installed all three LEDs light Figure 5a – Looping the Power Cord (AMBER CLASSIC X only) to indicate this status. Audio prompts announce AC, Telco, or battery problem, in the event of such a problem.
-
Page 6: Using Your System
2. Drill 3 holes on mounting wall and insert 3 screws into the bracket slots then tighten screws to For wall mounting rotate the bracket 180º secure bracket (see Figure 7b). 3. With the bracket mounted on the wall, position the Base Unit so that the top two hangers of the bracket are fitted onto their respective holes followed by the bottom hanger (see Figure 7c). -
Page 7: Calling For Emergency Assistance
Monitoring Center. The status must be changed to AWAY mode. The CHECK Base Unit's display (AMBER CLASSIC only) shows button should be held down for 5 seconds. The unit CALLING FOR HELP together with the name and announces and displays (AMBER CLASSIC only) number of the activated pendant. -
Page 8: Direct Link
If no activity is detected by the enrolled transmitter(s) during a pre-defined amount of time, the AMBER CLASSIC / AMBER CLASSIC X will report an inactivity condition to the Monitoring Center, which will initiate... -
Page 9: Testing Procedures
When the call will announce and display (AMBER CLASSIC only) ends, the telephone line returns to normal mode. "Please Test Your Pendant". The panel will also In the USER TEST mode, the Base Unit display (AMBER CLASSIC only) "Press Your... -
Page 10: Troubleshooting
Center. Respond to the message on the Base Unit's display (AMBER CLASSIC only). The display (AMBER CLASSIC No electrical power is being Check to see if there is a power only) shows POWER supplied to the Base Unit. The failure. - Page 11 68 rules and requirements adopted by ACTA and a properly installed RJ-31X connector. 3. If the AMBER CLASSIC / AMBER CLASSIC X causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If advance notice is not practical, you will be notified as soon as possible.
-
Page 12: Customer Premises Equipment And Wiring
GENERAL RF DISCLAIMER Due to the varying range of wireless systems, Visonic and its partners are not held liable if the system does not receive or process the RF transmitted communications signals as specified. Radio Waves pass through wood and plastic with very little attenuation (loss of signal strength).
Need help?
Do you have a question about the AMBER CLASSIC and is the answer not in the manual?
Questions and answers