Troubleshooting - Vinotemp VT-OUTDOORREF Owner's Manual

PROBLEMS WITH YOUR APPLIANCE
Most common problems can be solved easily, saving you the cost of a possible service
call. Try the following suggestions to see if you can solve the problem before
contacting Vinotemp at info@vinotemp.com.
PROBLEM
Appliance is not connected to a
Appliance power supply.
does not The appliance is turned off.
operate. Tripped circuit breaker or a blown
fuse.
The temperature is not set correctly.
The ambient temperature could
require a lower temperature setting.
The door was opened too often.
Appliance is
The door was not closed completely.
not cold
Door does not create an airtight seal.
enough.
The condenser is too dirty.
The ventilation opening is blocked or
too dusty.
The room temperature is higher than
average.
A large amount of food has been
Appliance added to the unit.
turns itself
on and off The door is open too often.
frequently.
The door is not closed completely.
The door gasket does not seal
properly.
Appliance is not connected to a
power supply.
The light
Tripped circuit breaker or a blown
does not
fuse.
work.
The light was switched off on the
control panel.
The appliance is not properly level.
Vibrations
There is a rattling noise.
The
appliance
There are gurgling sounds.
seems to
make too
much noise.
There are popping and cracking
noises.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

TROUBLESHOOTING

POSSIBLE CAUSE
i n f o @ v i n o t e m p . c o m
REMEDY
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Check the set temperature.
Set a lower temperature.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Clean the condenser when
necessary.
Clear the obstructions and clean
the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Level the appliance with the
adjustable feet.
This noise may be caused by the
internal flow of the refrigerant.
This is normal.
As each cycle ends, these sounds
may be caused by the flow of
refrigerant in the appliance.
These sounds are usually caused
by internal temperature
13