Table of Contents
Advertisement
NX-6A (Powered Near Field Studio Monitor)
Output level control
VOL
Rotating the VOL control clock-
wise increases the output level.
-
MAX
(0dB)
Tweeter level control
You can use the TWEETER con-
0dB
TWEETER
trol to adjust the tweeter level
within the range of +/- 3 dB.
The center position (0 dB) is the
+3
-3
nominal position. Turning the
control right boosts the tweeter
level, while turning it left drops
the level (see the graph right).
When the unit is shipped, the
TWEETER control is set to the
center (0 dB).
Names and functions
1. Power LED
Lights when power is turned on.
2. Output level control
Adjusts output level.
3. Tweeter level control
1
Adjusts tweeter level within a +/- 3dB range.
4. Low-frequency EQ control
Adjusts low frequency characteristics (around 55Hz range)
within a +/- 3dB range.
5. Unbalanced input terminal (Phone jack)
Accepts -10dBV unbalanced input.
2
3
6. Balanced input terminal (XLR-3-31 type)
Accepts +4dBu balanced input (hot pin is #2).
4
5
<CAUTION>:
input connectors cannot be used simultaneously. When the
6
unbalanced connector is plugged, the unbalanced input takes
priority and the balanced input is disabled.
7
7. Heatsink
<CAUTION>:
gets extremely hot. Do not touch the heatsink in such a con-
dition.
8
8. Power switch
Turn the power on or off. Make sure that the output level
control of the connected equipment is set to minimum when
9
turning on the power.
9. AC IN connector
Connects the AC cord provided.
Level controls and EQ
-3
110
90
70
(dB)
50
10
6
The balanced (XLR) and the unbalanced (phone)
If you use the NX-6A for a long time, the heatsink
Low (around 55Hz range) EQ
You can use the LO EQ control
0dB
LO EQ
to boost/cut the low frequency
(around 55Hz range) within the
range of +/-3 dB. Turning the
+3
control right boosts the low fre-
quencies, while turning it left
cuts the low frequencies (see
the graph below).
Wf +3dB
Wf -3dB
100
200
20
(Hz)
50
500
Tw +3dB
Tw -3dB
5k
10k
20k
1k
2k
50k
Advertisement
Table of Contents
