Table of Contents
Advertisement
Bendrange - Range of the oscillator using the pitch bend wheel.
Keytrack - At 100%, the oscillator follows the MIDI notes for each octave at twice the
frequency, which is the standard for most playable sounds. At 0%, it does not change the
pitch depending on the pressed MIDI note (e.g. for drums, effects etc.).
FM - The oscillator can be FM modulated by any source. Select the source from the drop-
down menu under FM and use the slider to control the amount.
Suboscillator - You can mix a square oscillator into the selected waveform. Select the
octave position using the buttons.
OSCILLATOR 3+2
MIXER
position) to pink. The two Parallel/Serial filter buttons switch the two filters parallel or in
series. Furthermore, the parameters of the mixer can be changed using the modulation
matrix.
KOMPLEXER Manual EN
Oscillator 3 does not have any wavetable
waveforms, but can be synchronized with
oscillator 2. You can set the pulse width of the
pulse waveform under PW and modulate it in
the modulation matrix on the MATRIX screen. If
Sync is activated, oscillator 3 is synchronized
with oscillator 2. Experiment with envelope
curves or LFOs in oscillator 2 in order to obtain
typical sync sounds. To do so, oscillator 3 must
be enabled and its level set to > 0 in the mixer.
The MIXER mixes together the
oscillator, the ring modulator
and noise. Use the Route
knobs to mix the respective
source to Filter 1 and/or Filter
2.
changes the color of the noise
from brown to white (middle
The
Color
parameter
15
Advertisement
Table of Contents
