Advertisement
How does looping work?
1
Select LOOP.
2
Make sure the pedal is in bypass mode (LED off). Feel the groove and prepare for recording. Then
press the switch to start your recording and play. The LED flashes red.
3
Press the switch again to stop recording. Flashback immediately starts playing the loop. In this
play mode the LED is green.
4
To overdub your recording press the switch once more. The LED now blinks.
5
To delete all recordings, double-click the switch.
Please note the following
-
The first round of recording always sets the length of the loop (1). If an overdub exceeds the length
of the loop (2), a third round of recording begins (3). This gives a very natural, logic and musical
feel when recording loops.
- The DELAY and FEEDBACK knobs are inactive in Loop mode.
11
Advertisement
