Troubleshooting - TC Electronic M2000 User Manual

TROUBLESHOOTING

You press the POWER switch but there is no light.
- The power switch on the rear panel is switched off.
The input PPM meters don't peak out.
- You are using analog inputs, but the input selector in the I/O menu is set to digital in.
- The analog input level is set too low.
Only left input PPM meter is showing a signal.
- Set input selector (in I/O menu) to Both
No sound through the M2000.
- You are using analog inputs, but the input selector in the I/O menu is set to digital in.
You can't turn the power off.
- Hold the power switch pressed for at least 3 seconds.
All Program sounds »phased«
- You are using the M2000 in combination with a mixing console (send/return), but have not set Mix to 100%. You can do this permanently
in the I/O menu.
Pedal works wrong
- Be sure the pedal is a »make« type.
32