TC Electronic G-System User Manual page 11

You must decide whether you use the Input on the
front or on the rear of the GFX01. This is
configured using the Input Select parameter in the
Global (Glb) Levels menu.
Loops 1 to 4 and Insert
• Connect up to four Overdrive/Distortion pedals – or
other mono effects – to the G-System's four loops.
Connect "Send" to the pedal's Input and connect the
pedal's Output to "Return".
• If you also wish to connect a pre-amp, use the Insert
loop. Connect the G-System's "Insert Send" to the
pre-amp's input and connect the pre-amp's output to
"Insert Return". Alternatively, a fifth stomp-box pedal
can be used in the Insert loop.
QUICK SETUP GUIDE
• Be sure to activate all the pedals that you have
connected in the loops.
• If your pedals require a 9V DC power supply, the G-
System provides 4 x 9V DC outlets (max 200mA
combined), so you won't need an external power-
supply.
If you are in doubt as to which type of power your pedals
require, you should consult the documentation that came
with the pedal. On some pedals there is also a small
label next to the power inlet, which you should check.
We are quite confident that once you have become
familiar with the G-System, you will find that it is both
easy to set up and customize. On the other hand, the
flexibility the G-System offers means that it comes with a
wealth of features that you may not want to utilize right
away. You may also come across features that you didn't
know you needed – until now!
9