Usb Connections; Audio Connections; Microphones; Guitars - Tascam US-366 Owner's Manual

USB connections

Use the included USB cable to connect the US-322/366 to your
computer as shown in the illustration. When the USB connection
is active, the USB indicator on the top of the unit lights.
CAUTION
Some USB devices access the USB bus frequently. To
avoid dropouts and clicks in the audio signal, we strongly
recommend that you do not connect any USB devices other
than keyboards and mice to the USB bus used by this unit.

Audio connections

Connect the output signal of your mic, guitar, keyboard, or other
audio device to the US-322/366, where it will be converted
into digital audio and sent via USB to your computer. Connect
the output of the US-322/366 to your speakers (via an amp) or
headphones, so you will be able to monitor the audio signals
coming into the US-322/366 or being produced by your
computer.
CAUTION
Before connecting an audio device, set the INPUT 1/2,
PHONES and LINE OUT knobs to their minimum values.
Failure to do so could cause loud noises, which might
damage equipment or harm the hearing of people nearby.
4 – Connections

Microphones

Connect microphones to the INPUT 1/L and INPUT 2/R MIC
connectors (XLR) on the front panel.
When using a condenser microphone that requires phantom
power, set the 48V switch on the front panel to ON.
When the 48V switch is set to ON, the 48V indicator on the top
panel lights.
CAUTION
• Connecting a dynamic microphone with an unbalanced
connection to the unit when the 48V switch is ON could
damage this unit and make it unusable.
• Do not connect or disconnect a mic with an input when this
switch is ON. Loud noises might be produced and damage
could be caused to equipment.
• Before turning a 48V switch ON or OFF, turn the output
volume down using the PHONES and LINE OUT knobs on
the front panel. Depending on the mic, loud noises might be
produced and damage could be caused to equipment or to
people's hearing.
• Always set the 48V switch to OFF before turning the unit's
power on or off (connecting or disconnecting the AC
adaptor).
• Do not use phantom power when line level equipment is
connected to an XLR connector. It might damage equipment.

Guitars

Connect a guitar or bass guitar to the INPUT 1/L LINE/GUITAR
jack on the front of the unit and set the MIC/LINE-GUITAR
switch on the top to GUITAR.
48V indicator
15
TASCAM US-322/366