Safety Information - Tascam DV-D01U Owner's Manual

Hide thumbs Also See for DV-D01U:
Table of Contents

Advertisement

Safety Information

This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified as
a class 1 laser product. There is no hazardous invis-
ible laser radiation during operation because invis-
ible laser radiation emitted inside of this product is
completely confined in the protective housings.
The label required in this regulation is shown at 1.
1
CAUTION
DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
I F T H I S P R O D U C T D E V E LO P S T R O U B L E ,
CONTACT YOUR NEAREST QUALIFIED SERVICE
PERSONNEL, AND DO NOT USE THE PRODUCT
IN ITS DAMAGED STATE.
Optical pickup:
Type
: OPA-652PH
Manufacturer : Arima Devices Co, Ltd.
Laser output : Less than 0.5 mW on the objective lens
Wavelength : DVD/650 to 660 nm
CD/770 to 810 nm

TASCAM DV-D01UT/C
Rack-mounting the Unit
If you are mounting the unit in a rack, leave 1U of
space above it and 4 inch (10 cm) or more of space
at the rear.
Use the rack-mounting kit to mount the unit in a
standard 19-inch equipment rack, as shown in this
section. Remove the feet of the unit before mounting.
For USA

Advertisement

Table of Contents
loading

Table of Contents