Safety Information - Tascam CD-355 Owner's Manual

Safety Information

This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified as
a class 1 laser product. There is no hazardous invis-
ible laser radiation during operation because invisible
laser radiation emitted inside of this product is com-
pletely confined in the protective housings.
The label required in this regulation is shown at 1.
CAUTION
• DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
• USE OF CONTROLS OR ADJUSTMENTS OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZ-
ARDOUS RADIATION EXPOSURE.
• IF THIS PRODUCT DEVELOPS TROUBLE, CON-
TACT YOUR NEAREST QUALIFIED SERVICE PER-
SONNEL, AND DO NOT USE THE PRODUCT IN
ITS DAMAGED STATE.
Optical pickup:
Type: SF-P101NXR
Manufacturer: SANYO Electric Co., Ltd
Laser output: Less than 0.5 mW on the objective
lens
Wavelength: 765 to 815 nm

TASCAM CD-355
Rack-mounting the Unit
Use the supplied rack-mounting kit to mount the unit
in a standard 19-inch rack, as shown below.
Remove the feet of the unit before mounting.
NOTE
• Leave 1U of space above the unit for ventilation.
• Allow at least 10 cm (4 in) at the rear of the unit for
ventilation.