Table of Contents
Advertisement
Quick Start Guide—Basic Operation
IMPORTANT SAFETY PRECAUTIONS
Using the Effects
To apply effects to the signal input through the mic, press the
key to open the
EFFECT
EFFECTOR
value is highlighted as shown below, use the
to select one of the effect banks (01–05).
After selecting an effect bank, select an effect preset by using
the down
(
) key to highlight the
CURSOR
¶
Then use the
keys to select a preset. Each preset
VALUE (+, –)
uses a different combination of effect modules. (See the
"Effect preset list" on page 39.)
Press the right
key (
CURSOR
adjustment screen. Use the
level.
1
TASCAM CD-VT2
screen. When the
VALUE (+, –)
PRESET
) to open the effect level
¥
keys to change the
VALUE (+, –)
NOTE
You can change the parameter settings for every effect.
BANK
(For details, see "Using built-in effects" on page 31.)
keys
Singing or playing along with a CD
You can listen to the sound from both a CD and your voice or
instrument at the same time through headphones. To change
the volume balance between the CD and the mic input, press
the
key to open the
LEVEL
key (
CURSOR
then use the
VALUE (+, –)
"Adjusting the input level" on page 30)
Turning off the power
value.
When you stop using the player, press the
the back of the unit for about one second. Release the switch
when "
TRAINER SERIES
Restoring all settings to original values
If you press and hold both the
the player power ON, the
After startup, follow the onscreen instructions and press the
to restore every effect parameter, playback setting
¥/π key
and other adjustable setting to the values they were set at when
they unit was shipped from the factory.
screen. Press the right
LEVEL
) to highlight the
¥
MIC 1 LEVEL
keys to adjust the mic volume. (See
" appears on the display.
and
µ
≤
screen appears.
INITIALIZE
value,
switch on
POWER
keys when you turn
Advertisement
Table of Contents
