Using.built-In.effects - Tascam CD-GT2 Owner's Manual

IMPORTANT SAFETY PRECAUTIONS
Using guitars and mics
Use the following procedures to adjust the CD playback signal
and input signal levels independently to achieve the mix
balance that you desire.
1 Press the key to open the
LEVEL
The and
GUITAR/MIC CD
the levels of the input signal from the
and the CD playback signal.
2 Use the ( ,
CURSOR
˙
you want to adjust. The level value of the selected knob
appears as a pop-up in inverse.
3 Use the keys to adjust the level. The level
VALUE (+, –)
knob icon rotates as you change the value.
0
TASCAM CD-GT2
screen.
LEVEL
knob icons appear. These adjust
GUITAR/MIC IN
) keys to select the knob that
¥
Using built-in effects
This device has a built-in multi-effects processor.
Depending on the
settings) on the
are usable. (See "Setting the input" on page 29.)
jack Press the
EFFECT
On the
EFFECTOR
select items and the
same way as on other screens. Use the
to move between level knobs and effect modules.
As shown in the figure above, in addition to
, the
PRESET EFFECTOR
knob and icons for up to three guitar or microphone effect
modules. The guitar or microphone icon shows whether
the effects that can currently be used are for a guitar or mic
and have no settings, but all other icons contain adjustable
settings. The types of effect modules change depending on the
GUITAR /MIC IN
When you select the
appears for the setting items. Use the
setting (
GUITAR/MIC IN
INPUT
screen, either the guitar or mic effects
LEVEL
key to open the
EFFECTOR
screen, use the
CURSOR
keys to adjust settings in the
VALUE (+, –)
CURSOR
screen also shows the
jack input setting.
knob or effect modules, a pop-up
LVL
CURSOR
jack input
screen.
( , ) keys to
§ ¶
( , ) keys
˙ ¥
and
BANK
(level)
LVL
( , ) keys to
§ ¶