Supermicro Supero X6DAL-B2 User Manual page 59

P-ATA Only
S-ATA Running Enhanced Mode
Select Yes if you want the function of Serial ATA Enhanced Mode
to be enabled at all times. Options are Yes and No.
P-ATA Channel Selection
This feature allows the user to select which channel to set the
Parallel ATA Mode. The options are: Primary, Secondary or Both.
S-ATA Ports Definition
This feature allows the user to configure Serial ATA Ports. The
options are: P0-3rd/P1-4th, P0-4th/P1-3rd
Configuring S-ATA as RAID
Select Yes to configure Serial ATA as RAID. The options are Yes,
and No.
S-ATA Only
S-ATA Ports Definition
This feature allows the user to configure Serial ATA Ports. The
options are: P0-1st/P1-2nd, P0-2nd/P1-1st
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third
IDE Master/Slave, Fourth IDE Master/Slave Sub Menu
From the Advanced Setup screen, press <Enter> to access this sub menu
for the primary, secondary, third and fourth IDE master and slave drives.
Use this screen to select options for the Primary and Secondary IDE drives.
Use the up and down <Arrow> keys to select an item. Use the <Plus> and
<Minus> keys to change the value of the selected option.
Type
Select the type of device connected to the system. The options are Not
Installed, Auto, CDROM and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk
drive. In the LBA mode, the maximum drive capacity is 137 GB. For drive
capacities over 137 GB, your system must be equipped with 48-bit LBA
mode addressing. If not, contact your manufacturer or install an ATA/133
IDE controller card that supports 48-bit LBA mode. The options are Dis-
abled or Auto.
.
.
4-7
Chapter 4: AMI BIOS