Table of Contents
Advertisement
Appendix D: Software Installation: Adaptec's SATA HostRAID Utility
Installing the Driver in an Existing Windows System
Please follow the steps listed below to install a driver in a system that
already has a Windows operating system:
1. Create a driver disk by following the instructions from the Web site or the
product CD.
2. Start Windows. Windows launches the Found New Hardware Wizard,
which searches for the controller driver.
3. Insert the driver disk you created in
Step
1. Select the floppy disk drive as
the source and click Next.
4. If necessary, select the appropriate driver for your operating system.
5. Click Next as needed to complete the controller installation.
6. Remove the driver disk.
7. If prompted, restart the computer.
8. Your installation is complete. If you want to create an array from the
BIOS, see
the section-"Adaptec RAID Configuration
Utility". If you want to
create an array from the operating system, see
the section-"Using Adaptec
Storage
Manager".
D-3
Advertisement
Table of Contents
