Table of Contents
Advertisement
Available languages
Available languages
Charging LED-ON: Indicates the battery is charging, virtually all the power from the solar array
passes through to the battery.
Float LED-ON Indicates full charge reached, a small "Float" charge continues to optimize battery
when needed.
The
icon (red LED) indicates reverse polarity and must be switched immediately.
The
icon (green LED) indicates "Charge Complete" at this point the battery is fully charged and the
charge controller is in float mode.
The bottom 3 LED indicator lights show the state of the battery. These functions are described below.
The
icon (yellow LED) indicates the battery voltage is greater than 12.5V.
The
icon (red LED) indicates the battery voltage is between 11.5V and 12.5V.
The
icon (red LED) indicates the battery voltage is less than 11.5V.
The
icon will blink if battery is disconnected from the unit. The charge controller will not function if
not connected to both the battery as well as the solar array. Testing may not be performed while the charge
connector is unhooked from one or both of the battery or solar array.
Technical Specifications
Parameters
Electrical
Normal Input (Solar Cell Array voltage)
Maximum Input
Maximum charging current
Current Consumption when connected to 15 volt array (battery not present)
Current consumption when connected to a 12 volt battery (array not
present)
PWM constant voltage for Gel Cell battery
PWM constant voltage for Lead Acid battery
Float mode voltage
Battery Condition Display:
LED light indicated range
LOW (red)
FAIR (yellow)
GOOD (green)
Protection:
Over temperature protection engages at (stop charging)
Over temperature protection resets at (restart charging)
Data
17-22 volts
25 volts
30 amps
maximum 35mA
Maximum 25mA
14.1 volts +/-0.4
14.5 +/-0.4
13.4 +/-0.4
<11.5 +/-0.4
11.5 to 12.5 +/-0.4
>12.5+/-0.4
>80°C (176°F)
<65°C (149°F)
Hide quick links:
Advertisement
Table of Contents
