Table of Contents
Advertisement
Configuring your networks
Configuring your networks
Completing the configuration
Configuring the out of band management interface
Setting the date and time
Changing antivirus protection
66
If you are running the FortiGate unit in NAT/Route mode, your networks must be
configured to route all Internet traffic to the IP address of the FortiGate interface to
which they are connected.
Make sure that the connected FortiGate unit is functioning properly by connecting to
the Internet from a computer on your internal network. You should be able to connect
to any Internet address.
Use the information in this section to complete the configuration of the FortiGate unit.
Use the following procedure to configure the out of band management interface:
1
Log into the web-based manager.
2
Go to System > Network > OOB Management.
3
Change the IP/Netmask addresses and the Default Gateway using the information in
Table 22 on page
4
Select Apply.
For effective scheduling and logging, the FortiGate system date and time must be
accurate. You can either manually set the system date and time or configure the
FortiGate unit to automatically keep its time correct by synchronizing with a Network
Time Protocol (NTP) server.
For information about setting the FortiGate system date and time, see
date and time" on page
To change how antivirus protection to protects users on your internal network from
downloading a virus from the Internet:
1
Go to Firewall > Policy > Internal->External.
2
Select Edit
to edit this policy.
3
Select Anti-Virus & Web filter to enable antivirus protection for this policy.
4
Select a different Content Profile to change how antivirus protection is applied for this
policy.
For a description of each of the content profiles, see
5
Select OK to save the changes.
63.
175.
NAT/Route mode installation
"Setting system
"Content profiles" on page
223.
Fortinet Inc.
Advertisement
Table of Contents
