Service And Maintenance - Stiga PARK PRO 20 Instructions For Use Manual

GB
CATALYTIC CONVERTER
(Pro20 Cat)
The catalytic converter gets very hot during opera-
tion. The heat remains for a long time after the en-
gine has been stopped. Be aware of the fire risk.
Do not park in close proximity to in-
flammable objects. Do not cover the
machine until the catalytic converter
has cooled down.
STEERING AID (Pro20)
Built-in function in order to facilitate steering. The
operator only has to turn the steering wheel gently.
A hydraulic torque amplifier creates the remaining
force.
As opposed to normal servo steering (e.g. in a car),
the steering aid has a limited capacity. This means
that it has some characteristics that might be con-
sidered negative:
- at a low engine rpm or in situations where extra
steering force is needed, steering can be consid-
ered to be "jumpy".
- the machine should always be moving when the
steering is used. Avoid turning the steering
wheel when the machine is standing completely
still and the accessory is in the lowered working
position.
The steering is adapted in order to produce better
results at a normal working speed. This produces
major benefits.
Even when the engine is not running, the steering
works. However, it is harder to turn in this case, if
the machine is to be manoeuvred manually.
DRIVING TIPS
Make sure that there is the correct quantity of oil in
the engine when driving on slopes (oil level on
"FULL").
Be careful when driving on slopes. No
sudden starting or stopping when mov-
ing up or down a slope. Never drive
across a slope. Move from the top down,
and from the bottom to the top.
The machine, equipped with original
accessories, may not be driven on slopes
greater than 10º in any direction.
14
ENGLISH
Reduce the speed on slopes and when
making sharp turns to prevent the ma-
chine from tipping over or you losing
control of the machine.
Do not turn the steering wheel to full
lock when driving in top gear and at full
throttle. The machine can easily topple
over.
Keep hands and fingers well away from
articulated steering joint and seat
bracket. Risk of crushing injuries. Nev-
er operate the machine without the en-
gine casing.

SERVICE AND MAINTENANCE

SERVICE PROGRAM
In order to keep the machine in good condition, as
regards reliability and operational safety as well as
from an environmental perspective, STIGA's serv-
ice program should be followed.
The contents of this program can be found in the
attached service log.
We recommend that an authorised workshop car-
ries out every service. This guarantees that the
work is performed by trained personnel and with
genuine spare parts.
At every service, the service log should be
stamped. A "fully stamped" service log is a valua-
ble document that improves the machine's second-
hand value.
PREPARATIONS
Unless otherwise stated, all service and mainte-
nance must be carried out on a stationary machine
when the engine is not running.
Prevent the machine from rolling by al-
ways applying the parking brake.
Prevent unintentional starting of the
engine by always stopping the engine,
disconnecting the spark plug cable
from the spark plug and earthing it.
Disconnect the negative cable from the
battery.