Sonnet Fusion RAID Storage Systems Operation Manual page 77

Appendix A - CLI ASCII-Based Interface
• SESIdentify (Disabled on Error)
Commands the appropriate SES enclosure to identify the
specified element(s). All identifies all disks. RAID and RAID
group name identifies all disks in a RAID group. If the
MemberIndex is also specified, only that disk is identified.
Drive and BlockDevID identifies the specified disk.
set SESIdentify [all | RAID GroupName
<MemberIndex> | drive BlockDevID]
get SESIdentify
• SESIdentifyStop (Immediate, Disabled on Error)
Commands the appropriate SES enclosure to stop identifying the
specified element(s). All stops identifying all enclosures' drive
slots. RAID and RAID group name stops identification of all disks
in a RAID group. Drive and BlockDevID stops identification of
the specified drive.
SESIdentifyStop [All | RAID GroupName
<MemberIndex> | Drive BlockDevID]
• SESMute (Immediate, Disabled on Error)
Causes all known enclosures' audible alarms to be set to either
the mute or remind state. The default action is mute. The
enclosure index qualifier is optional. The optional parameter
Remind may be specified to set the remind state, which causes
an occasional audible reminder of the alarm condition (if
supported). Note that SESEnclosures must be executed prior to
executing SESMute.
SESMute <EnclIdx> <Remind>
• SESPoll (Enabled, Disabled on Error)
Specifies the SES enclosure polling interval in seconds. At the
specified interval, all known SES enclosures are polled for their
current status. A setting of 0 disables SES enclosure polling.
Default: 60
set SESPoll [0 | 30-3600
get SESPoll
• SESStartingSlot (Disabled on Error)
Establishes the starting slot/ID number for all attached SES
enclosures.
set SESStartingSlot [0 | 1]
get SESStartingSlot
• SESStatus (Immediate, Disabled on Error)
Displays the last polled status of the specified element type
in the specified enclosure. SupportLevel indicates the SES
features supported by the specified enclosure: fan, power, temp,
alarm, drive LEDs. If no element type is specified, all status is
displayed. Note that SESEnclosures must be executed prior to
executing SESStatus.
SESStatus [EnclIdx] <enc | drive | fan | power
| temp | alarm | SupportLevel>
• T ime (Disabled on Error)
S ets or displays the current time in 24 hour format.
set Time [HH: MM: SS]
get Time
• T imeZone
Sets or displays the time zone or an offset from GMT. GMT
offset must be in the format +/-HH:MM
set TimeZone [[EST | CST | MST | PST] | [[+|-]
[HH] : [MM]]]
get TimeZone
• V erboseMode (Enabled)
Controls the level of detail in CLI Help output and command
response output.
set VerboseMode [enabled | disabled]
get VerboseMode
• V irtualDriveInfo (Immediate)
Displays characteristics and statistics for all the available virtual
drives or any available virtual drive identified by its virtual
drive ID.
VirtualDriveInfo <Virtual Drive ID>
• W rapEventLog (Enabled, Disabled on Error)
When enabled, the unit logs up to 2,048 event entries before
wrapping (overwriting the first entries). If disabled, the unit
stops logging event entries when the buffer is full.
set WrapEventLog [enabled | disabled]
get WrapEventLog
xiii