• If unusual smells, sounds, or smoke come from the device, or if liquids enter it, disconnect the power cable immediately. • Follow the instructions in this manual carefully; contact Sonnet Customer Service for additional advice not covered in this manual.
Page 3
Fusion F2 Setup Connect Fusion F2 to SATA Host Controller This section describes the connection of the Fusion F2 drive enclosure to a SATA host controller card. 1. Connect the supplied eSATA data cables between Fusion F2 and the SATA host controller in your computer; verify the connec- tors are plugged in securely (Figure 3).
Page 4
Fusion F2 Setup Windows Drive Formatting & Configuration Support Note: The drives included with Fusion F2 are formatted using the GUID partition table for use with Intel- based Mac computers. In order to use Fusion F2 with your Windows computer, you must reformat the drives following the directions below.
The Sonnet web site located at www.sonnettech.com has the most current support information and technical updates. Before you call Sonnet Customer Service, please check our web site for the latest updates and online support files, and check this User’s Guide for helpful information.