Table Of Contents; Default: Blank; Valid Values: E.g. <*1; Key Is Pressed On The Phone - Snom Configuring phones for Mass Deployment Frequently Asked Questions Manual

Default: blank
Description: Prefix used for reaching outside numbers via an H323 gateway. This prefix
will be replaced by the gateway_prefix in a dialed number for calling outside numbers (see
gateway_prefix).
gateway_prefix
Valid values: e.g. <*5>

Default: blank

Description: Prefix with which an ISDN gateway is registered at the gatekeeper. The phone
will replace this prefix with the external_line_prefix in a dialed number if it is starting with
the external_line_prefix (see external_line_prefix).
Hence the user doesn't have to dial numbers like 5*1234567 but can instead dial 01234567
with the same effect.
PBX key codes (H.323 only)
key_seq_hold_on
Valid values: e.g. <*1>
Default: blank
Description: Key code that is sent by the phone to the PBX if it is set and the "R" (hold on)
key is pressed on the phone.
key_seq_hold_off
Valid values: e.g. <*2>
Default: blank
Description: Key code that is sent by the phone to the PBX if it is set and the "R" (hold off)

key is pressed on the phone.

key_seq_transfer_blind
Valid values: e.g. <*60#>
Default: blank
Description: Key code that is sent by the phone to the PBX if it is set and the "Xfer" key is
pressed on the phone for a blind transfer.
key_seq_transfer_consultation
Valid values: e.g. <*6>
Default: blank
Description: Key code that is sent by the phone to the PBX if it is set and the "Xfer" key is
pressed on the phone for a consultation transfer. The phone needs to have two active calls
in order to use this feature.
key_seq_divert
Valid values: e.g. <*3>
Default: blank
Confi guring snom phones for Mass Deployment
[ F A
R E Q U E N T L Y
Q
S K E D U E S T I O N
]
13