Table of Contents
Advertisement
Gas burners
On the control panel, the following symbols are indicated
around each knob "M" or on the knob itself: Cock
Off
High flame
Low flame
Moreover, the symbols
position of the relative burner on the hob.
The burners are fitted with a safety thermocouple device
against gas leaks. This device interrupts the gas supply
should the burner flame go out during operation.
To light one of the burners, proceed as follows:
• turn the relative knob anti-clockwise until the pointer is
on the high-flame symbol;
• press the knob down fully to actuate the automatic gas
ignition;
• keep the knob pressed down for about 6 seconds with
the flame lit to allow the safety thermocouple to heat;
• release the knob, checking that the flame is stable. If it is
not, repeat the operation.
For minimum power, turn the knob towards the low flame
symbol. Intermediate positions are possible by simply
setting the knob anywhere between the high and the low
flame symbol.
Important:
• Do not actuate the automatic ignition device for more
than 15 consecutive seconds.
• Difficulty in ignition is sometimes due to air inside the
gas duct.
• If a burner flame accidentally goes out, the gas continues
to exit for a few moments before the safety device is
actuated. Turn the control knob to the off position and do
not attempt ignition again for at least 1 minute, thereby
letting the gas disperse, which could otherwise be a
danger.
• When the appliance is not in operation, check that the
knobs are set to the off position " ". The main gas supply
cut-off cock should also be turned off.
Practical advice on using the burners
To obtain maximum efficiency from the burners, we
recommend you only use pans with a diameter suitable for
the burner being used, so that the flame does not extend
beyond the pan base (see the following table).
When a liquid starts boiling, we recommend you turn the
flame down just enough to keep the liquid simmering.
AUS
INSTRUCTIONS FOR USE
near the knobs indicate the
Burner
A.Auxiliary
B.Semi-rapid
C.Rapid
I.Triple ring
I.Double ring DC-DR (inner)
I.Double ring DC-DR (outer)
The hob is fitted with two reducing pan
stands (fig. 2), which should only be used
on auxiliary burner "A" and on the DC-DR
(inner) "I".
The "dual independent flame" burner
This gas burner consists of two concentric burner rings which
can be actuated together or independently. When the two
rings are used together at the highest setting, the burner
reduces the length of cooking time with respect to traditional
burners. The dual ring also distributes heat more evenly on
the bottom of cookware, especially when both burner rings
are used at the lowest setting. Cookware of any size can be
used. If small pots or pans are used, only turn the inner
burner on. Each burner ring has its own control knob:
the knob indicated by symbol
the knob indicated by symbol
To turn on one of the two rings, press the relative knob in all
the way and turn it anti-clockwise to the maximum setting
The burner is fitted with an electronic ignitor that is
actuated automatically when the knob is pressed.
Since the burner is fitted with a safety device "F", the
knob should be pressed for approximately 6 seconds for
the device keeping the flame lit automatically to heat up.
To turn the burner off, turn the knob clockwise until it
stops (corresponding again with the "
For the best performance of your burners, keep the following
in mind: All types of pans can be used on the burners. The
important thing is that the bottom should be completely
even.
3
ø Pan Diameter (cm)
6 – 14
15 – 20
21 – 26
24 – 26
10 - 14
24 - 26
fig.2
controls the inner ring;
controls the outer ring;
" symbol).
Hide quick links:
Advertisement
Table of Contents
