Check software version
Please note – instructions are based on an 80GB iPod classic – the route path is common to all
variants.
Place an iPod / iPhone in the rCubes docking receptacle
• Navigate to settings (click)
• Navigate to about (click)
You will now see information regarding the iPods capacity/memory usage navigate to screen
four as indicated by the dots at the bottom of the screen and you should see the below or
similar.
In this instance we can see that the Software version is V1.07.
To update software
Download the latest SW version available from support@arcam.co.uk or local distributor.
Load this onto a USB memory stick (this needs to be a standard memory stick not on that
carries a boot loader such a Cruzors).
• With the cube in standby
• Press and hold the top plate standby button for +5 seconds
• Standby LED should start to flash with a frequency of 2 time a second
• Place memory stick in rear panel port
• LED will now strobe very quickly and the rCube will reset after 15 seconds
• Remove USB stick
• Power cycle rCube (rear panel switch) Check that software version is as expected using
iPod as in previously explained procedure.
rCube
Model rCube
Manufacturer Arcam
Serial number
Version V1.07
****